{"product_id":"grundfos-hydro-mpc-e-2-x-crie-5-2-single-phase-0-55kw-variable-speed-304ss-booster-system-w8l-tank-cu-352","title":"Grundfos Hydro MPC-E 2 x CRIE 5-2 Single Phase 2 x 0.55kW 304ss Booster System w\/8L Tank and CU 352 Controller","description":"\u003cp\u003eIn cafe strips and small assemblies where a dishwasher cycle drops the street pressure, the simultaneous demand of the morning peak places heavy loads on the supply; the Hydro MPC-E 2 CRIE 5-2 answers with two CRIE 5-2 pumps operating in parallel. The complete system ships factory assembled and tested under part number 93637517.\u003c\/p\u003e\u003cp\u003eIt handles flows up to 329 L\/min across the system. The pumps can develop up to 19 metres of head when pressure demand increases. A Grundfos GENIECON PANEL on the common base frame provides the system control; the GENIECON UNIT within it holds the exact hydraulic and electrical data of the pumps, so staging and changeover decisions are based on the pumps' actual curves.\u003c\/p\u003e\u003cp\u003eFactory assembled on a common base, the set combines stainless steel pipework, two 50 mm manifold connections, isolation and non-return valves, pressure sensors and a gauge, plus an 8L diaphragm tank. It connects to a 1 x 230 V supply at 50 Hz with a rated current of 6.7 A. Motors are protected to IP54, while maximum system pressure is 16 bar. Liquid-temperature suitability is 5°C to 60°C.\u003c\/p\u003e\u003cp\u003eIts home ground covers commercial buildings, industry and irrigation schemes. The variable-speed system suits clean-water boosting duties with changing demand.\u003c\/p\u003e\u003cp\u003e\u003cstrong\u003eFeatures\u003c\/strong\u003e\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003eThe touch-panel GENIECON interface shows system status and allows direct setpoint changes on the door.\u003c\/li\u003e\n\u003cli\u003eInlet pressure monitoring provides dry-running protection if the suction supply is insufficient.\u003c\/li\u003e\n\u003cli\u003eThe package is wet-tested and pre-configured, requiring only pipework and power on site.\u003c\/li\u003e\n\u003cli\u003ePump staging follows demand automatically: pumps enter at low speed as pressure drops, ramp to equal speed, and exit as flow fades.\u003c\/li\u003e\n\u003cli\u003eVariable speed comes from frequency converters matched to  permanent magnet motors, keeping the booster set in its efficient range.\u003c\/li\u003e\n\u003cli\u003eMaximum operating pressure of 16 bar with motors sealed to IP54.\u003c\/li\u003e\n\u003cli\u003eStainless steel manifolds provide two 50 mm manifold connections ready for pipework.\u003c\/li\u003e\n\u003cli\u003eBoth constant-pressure and proportional-pressure modes are available, so plant rooms can tune response to pipework.\u003c\/li\u003e\n\u003cli\u003eControl decisions come from real pump curves, not generic models, via the GENIECON UNIT.\u003c\/li\u003e\n\u003cli\u003eTwo Grundfos CRIE 5-2 vertical multistage pumps run in parallel on one common base frame.\u003c\/li\u003e\n\u003cli\u003eThe set ships with an 8L precharged diaphragm tank for low-flow stability.\u003c\/li\u003e\n\u003cli\u003eEach main pump is rated 0.55 kW (P2), so per-pump draw scales down as speed follows demand.\u003c\/li\u003e\n\u003cli\u003eEnergy draw matches the actual job because speed follows demand, not a fixed curve.\u003c\/li\u003e\n\u003c\/ul\u003e\u003cp\u003e\u003cstrong\u003eWhat's Included\u003c\/strong\u003e\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003e2 x Grundfos CRIE 5-2 vertical multistage pumps\u003c\/li\u003e\n\u003cli\u003eIE5 permanent magnet motors with integrated frequency converters\u003c\/li\u003e\n\u003cli\u003eGENIECON PANEL with touch display\u003c\/li\u003e\n\u003cli\u003eGENIECON multi-pump control unit\u003c\/li\u003e\n\u003cli\u003eStainless steel suction manifold\u003c\/li\u003e\n\u003cli\u003eStainless steel discharge manifold\u003c\/li\u003e\n\u003cli\u003eNon-return valves\u003c\/li\u003e\n\u003cli\u003eIsolation valves\u003c\/li\u003e\n\u003cli\u003ePressure sensors\/transmitters\u003c\/li\u003e\n\u003cli\u003ePressure gauge\u003c\/li\u003e\n\u003cli\u003eInlet pressure monitoring (dry-run protection)\u003c\/li\u003e\n\u003cli\u003e8L diaphragm pressure tank\u003c\/li\u003e\n\u003cli\u003eFactory assembled and tested booster system\u003c\/li\u003e\n\u003c\/ul\u003e","brand":"Grundfos","offers":[{"title":"Default Title","offer_id":51383710843127,"sku":"93637517","price":28772.7,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0927\/0116\/3767\/files\/grundfos-hydro-mpc-e-2-x-crie-5-2-single-phase-0-55kw-variable-speed-304ss-booster-system-w8l-tank-cu-352.png?v=1792667788","url":"https:\/\/foundationpumps.com.au\/products\/grundfos-hydro-mpc-e-2-x-crie-5-2-single-phase-0-55kw-variable-speed-304ss-booster-system-w8l-tank-cu-352","provider":"Foundation Pumps","version":"1.0","type":"link"}