{"product_id":"grundfos-hydro-mpc-e-3-x-crie-10-3-three-phase-2-2kw-variable-speed-304ss-booster-system-w8l-tank-cu-352","title":"Grundfos Hydro MPC-E 3 x CRIE 10-3 Three Phase 3 x 2.2kW 304ss Booster System w\/8L Tank and CU 352 Controller","description":"\u003cp\u003eFor gymnasiums, aquatic centres and student housing running wall-to-wall showers, a factory-assembled Hydro MPC-E 3 CRIE 10-3 package provides a well-matched solution, with three CRIE 10-3 pumps staged against the demand curve. Quote part number 93637559 to have it arrive pre-configured and ready for the plant room.\u003c\/p\u003e\u003cp\u003eThe system supports flow rates up to 781 L\/min. It can develop up to 43 metres of head for dependable pressure boosting. Control sits with the GENIECON multi-pump controller in its touch-equipped panel, adjusting each pump individually and rotating duty by load, run hours and faults.\u003c\/p\u003e\u003cp\u003eFactory assembled on a common base, the set combines stainless steel pipework, two 80 mm manifold connections, isolation and non-return valves, pressure sensors and a gauge, plus an 8L diaphragm tank. It connects to a 3 x 400 V supply at 50 Hz with a rated current of 12.9 A. Motors are protected to IP54, while maximum system pressure is 16 bar. Liquid-temperature suitability is 5°C to 60°C.\u003c\/p\u003e\u003cp\u003eExpect it on commercial buildings and irrigation schemes sites, plus water supply networks duties. It provides clean-water pressure boosting for both new plant rooms and refits.\u003c\/p\u003e\u003cp\u003e\u003cstrong\u003eFeatures\u003c\/strong\u003e\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003eBoth constant-pressure and proportional-pressure modes are available, so plant rooms can tune response to pipework.\u003c\/li\u003e\n\u003cli\u003ePumps are cut in and out according to demand, every running unit turning at the same speed to hold the pressure set point.\u003c\/li\u003e\n\u003cli\u003eAn integrated 8L diaphragm tank carries small draw-offs and limits pump cycling.\u003c\/li\u003e\n\u003cli\u003eVariable speed comes from frequency converters matched to  permanent magnet motors, keeping the booster set in its efficient range.\u003c\/li\u003e\n\u003cli\u003eThe stainless steel manifold assembly is supplied with two 80 mm manifold connections.\u003c\/li\u003e\n\u003cli\u003eAt P2 each main pump is 2.2 kW, covering the duty without oversizing the frame.\u003c\/li\u003e\n\u003cli\u003eInlet pressure monitoring provides dry-running protection if the suction supply is insufficient.\u003c\/li\u003e\n\u003cli\u003eSlow-speed duty and staged switching keep consumption down through low-demand hours.\u003c\/li\u003e\n\u003cli\u003eThe GENIECON UNIT applies the pumps' exact hydraulic and electrical data when making control decisions.\u003c\/li\u003e\n\u003cli\u003eThe touch-panel GENIECON interface shows system status and allows direct setpoint changes on the door.\u003c\/li\u003e\n\u003cli\u003eMaximum operating pressure of 16 bar with motors sealed to IP54.\u003c\/li\u003e\n\u003cli\u003eThree Grundfos CRIE 10-3 pumps share the boosting work in parallel.\u003c\/li\u003e\n\u003cli\u003eFactory assembled and wet-tested, the set arrives pre-configured for straightforward installation.\u003c\/li\u003e\n\u003c\/ul\u003e\u003cp\u003e\u003cstrong\u003eWhat's Included\u003c\/strong\u003e\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003e3 x Grundfos CRIE 10-3 vertical multistage pumps\u003c\/li\u003e\n\u003cli\u003eIE5 permanent magnet motors with integrated frequency converters\u003c\/li\u003e\n\u003cli\u003eGENIECON PANEL with touch display\u003c\/li\u003e\n\u003cli\u003eGENIECON multi-pump control unit\u003c\/li\u003e\n\u003cli\u003eStainless steel suction manifold\u003c\/li\u003e\n\u003cli\u003eStainless steel discharge manifold\u003c\/li\u003e\n\u003cli\u003eNon-return valves\u003c\/li\u003e\n\u003cli\u003eIsolation valves\u003c\/li\u003e\n\u003cli\u003ePressure sensors\/transmitters\u003c\/li\u003e\n\u003cli\u003ePressure gauge\u003c\/li\u003e\n\u003cli\u003eInlet pressure monitoring (dry-run protection)\u003c\/li\u003e\n\u003cli\u003e8L diaphragm pressure tank\u003c\/li\u003e\n\u003cli\u003eFactory assembled and tested booster system\u003c\/li\u003e\n\u003c\/ul\u003e","brand":"Grundfos","offers":[{"title":"Default Title","offer_id":51383712153847,"sku":"93637559","price":45680.8,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0927\/0116\/3767\/files\/grundfos-hydro-mpc-e-3-x-crie-10-3-three-phase-2-2kw-variable-speed-304ss-booster-system-w8l-tank-cu-352.png?v=1792667837","url":"https:\/\/foundationpumps.com.au\/products\/grundfos-hydro-mpc-e-3-x-crie-10-3-three-phase-2-2kw-variable-speed-304ss-booster-system-w8l-tank-cu-352","provider":"Foundation Pumps","version":"1.0","type":"link"}