{"product_id":"grundfos-hydro-multi-e-2-x-cre-10-4-three-phase-1-5kw-variable-speed-booster-pump-set-24l-tank","title":"Grundfos Hydro Multi-E 2 x CRE 10-4 Three Phase 2 x 1.5kW Variable Speed Booster Pump Set with 24L Tank","description":"\u003cp\u003eAged-care villages and medical centres that cannot tolerate pressure swings rely on booster systems with no tolerance for pressure variation, and the Hydro Multi-E 2 CRE 10-4 is engineered for exactly that duty. Specify part number 99614349 and the whole set lands tested, assembled and ready for pipework.\u003c\/p\u003e\u003cp\u003eFlow capacity reaches 453 L\/min. Up to 57 metres of head is available to maintain pressure as demand changes. Because every pump carries its own frequency converter and the Multi-Master software elects the controlling pump itself, losing a control unit or pressure sensor means seamless handover rather than a shutdown.\u003c\/p\u003e\u003cp\u003eFor installation, the booster is supplied pre-assembled with stainless steel manifolds, two 50 mm manifold connections, isolation valves, non-return valves, pressure sensors and a gauge, plus a 24L diaphragm tank. It is designed for 3 x 380-415 V power at 50 \/ 60 Hz with a rated current of 6.2 A, with IP54 motor protection and a 10 bar maximum system pressure. Liquid-temperature suitability is 5°C to 60°C. Inlet pressure is rated to 10 bar.\u003c\/p\u003e\u003cp\u003eExpect it on schools and universities and hospitals sites, plus high-rise apartments duties. It provides clean-water pressure boosting for both new plant rooms and refits.\u003c\/p\u003e\u003cp\u003e\u003cstrong\u003eFeatures\u003c\/strong\u003e\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003eBoth constant-pressure and proportional-pressure modes are available, so plant rooms can tune response to pipework.\u003c\/li\u003e\n\u003cli\u003eThe package is wet-tested and pre-configured, requiring only pipework and power on site.\u003c\/li\u003e\n\u003cli\u003eThe set ships with an 24L precharged diaphragm tank for low-flow stability.\u003c\/li\u003e\n\u003cli\u003eFrequency converters on the motors pair with IE5 permanent magnet motors for efficient part-load operation.\u003c\/li\u003e\n\u003cli\u003eIntegrated Grundfos GO compatibility supports configuration, logging and diagnostics from a phone.\u003c\/li\u003e\n\u003cli\u003ePower use precisely tracks demand, avoiding the waste of fixed-speed alternates.\u003c\/li\u003e\n\u003cli\u003eMulti-Master redundancy means either pump can act as controller, with seamless changeover on fault.\u003c\/li\u003e\n\u003cli\u003eThe stainless steel manifold assembly is supplied with two 50 mm manifold connections.\u003c\/li\u003e\n\u003cli\u003eTwo Grundfos CRE 10-4 vertical multistage pumps run in parallel on one common base frame.\u003c\/li\u003e\n\u003cli\u003ePumps are cut in and out according to demand, every running unit turning at the same speed to hold the pressure set point.\u003c\/li\u003e\n\u003cli\u003eMaximum operating pressure of 10 bar with motors sealed to IP54.\u003c\/li\u003e\n\u003cli\u003eDry-running protection is built into the control, protecting the pumps if the suction supply is interrupted.\u003c\/li\u003e\n\u003cli\u003eEach main pump is rated 1.5 kW (P2), so per-pump draw scales down as speed follows demand.\u003c\/li\u003e\n\u003c\/ul\u003e\u003cp\u003e\u003cstrong\u003eWhat's Included\u003c\/strong\u003e\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003e2 x Grundfos CRE 10-4 vertical multistage pumps\u003c\/li\u003e\n\u003cli\u003eIE5 permanent magnet motors with integrated frequency converters\u003c\/li\u003e\n\u003cli\u003eStainless steel suction manifold\u003c\/li\u003e\n\u003cli\u003eStainless steel discharge manifold\u003c\/li\u003e\n\u003cli\u003eNon-return valves\u003c\/li\u003e\n\u003cli\u003eIsolation valves\u003c\/li\u003e\n\u003cli\u003ePressure sensors\/transmitters\u003c\/li\u003e\n\u003cli\u003ePressure gauge\u003c\/li\u003e\n\u003cli\u003e24L diaphragm pressure tank\u003c\/li\u003e\n\u003cli\u003eFactory assembled and tested booster system\u003c\/li\u003e\n\u003c\/ul\u003e","brand":"Grundfos","offers":[{"title":"Default Title","offer_id":51383700553975,"sku":"99614349","price":20656.9,"currency_code":"AUD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0927\/0116\/3767\/files\/grundfos-hydro-multi-e-2-x-cre-10-4-three-phase-1-5kw-variable-speed-booster-pump-set-24l-tank.png?v=1792667549","url":"https:\/\/foundationpumps.com.au\/products\/grundfos-hydro-multi-e-2-x-cre-10-4-three-phase-1-5kw-variable-speed-booster-pump-set-24l-tank","provider":"Foundation Pumps","version":"1.0","type":"link"}